Driger V2

From Beywiki, the Beyblade Encyclopedia - Presented by the World Beyblade Organization
Revision as of 21:41, 10 October 2007 by G (talk | contribs)

Jump to: navigation, search
Driger Vulcan 2
Number: A-75
System: 5-Layer/Magnacore
Type: Balance

Attack Ring (AR): Upper Claw

  • Weight: 7 grams

The AR of Driger V2 is built purely for upper attack by having two upper attack ramp points. With an attack surface that dips to the level of the weight disc, it it is able to perform an upper attack by lifting the opposing blade. However, the rather shallow lifting curve serverly limits the lifting potential of this AR, and was generally outclassed by other upper attackers. However, the upper attack on this AR can be improved in unison with its SP Upper Attack.

* Note The Hasbro Driger V2 has reinforced plastic making it more durable than the Takara version.

Use in Upper Attack Combos

Weight Disk (WD): 10-Balance

See 10-Balance

Spin Gear (SG): Neo SG Right (MW Core)

See Neo SG Right

Blade Base (SP): Upper Attack

  • Weight: 4 grams

Upper Attack is the heaviest SP. Like with its AR Upper Claw, it is purely built for upper attack because of its ramp like shape. The problem with Upper Claw was that it was built for upper attack, but it wasn't steep enough on its own to have an efficient upper attack. It was solved when it was used with the Upper Attack SP. When used together, the SP would extend the Beylade's overall slopes or ramps allowing for an efficient upper attack.

Unlike with Upper Claw, the Upper Attack SP can be efficient on its own not relying on another part. Since Upper Claw is a support part, it has the advantage over upper attack ARs in terms of having a lower starting ramp point. Because of this, the SP can serve as the main point of attack instead of having the AR do that.

Use in Upper Attack Combinations

Here is an example of how the Upper Attack SPs can be used on its own without the AR being the main attack part.

In order to focus on attacking with the support part only, smaller parts aside from the SP and BB must be used thus the reasoning for the use of a small AR such as Try Cutter (Polta). A 10-Heavy is used because it is fairly compact with a reasonable amount of weight to control the SG. The SG uses the shaft from Driger F because it is fast.

* Note refer to Adding a Different SG if you do not know how to setup the SG.

Blade Base (BB): Customize Change

  • Weight: 7 grams